![]() In other words, you can’t have the cover open too little … or too much or the button won’t be pressed and it won’t work. This specific keypad has a slide cover that needs to be in a precise position to get activated because it presses a small button that’s underneath the cover. If you face an issue at any point in the garage door installation process, you’re not alone. You’re all set from there! Common Questions with the Genie Garage Door Opener I’m dealing with issues with the light not flashing. In this 30 second window, you’ll need to press the code you want and hit “send” twice. You have 30 seconds from when you see the light to go back to the wireless keypad and sync it up to the garage door opener. Here’s where a little adrenaline comes in. Press the “learn” button and look for a light to flash. With a step ladder, open the garage door opener light cover. Step 3: Sync The Garage Door Opener With the Remote Keypad The flashing light you’ll see on the garage door opener light cover Once you see the LED flashing at a low pace, press in your new code again. Make sure the cover is fully open and enter your new code. Step 2: Program Your New Garage Door Opener Code This is the red light you should see when you’re programming a new code So try adjusting the slider cover and give it a go again. That’s why it’s important to only open it partially while holding down the “8” and “Program” keys. There’s a little button underneath the slider that needs to be activated in order for this process to work. Tip: Don’t see the lights flashing? Don’t worry. Once you see the light flash that means your codes are erased and you’re ready to move on to the next step. ![]() While holding down those keys, slide the cover completely open until you see the light flash. To do that, partially open the cover and hold down the “8” and “Program” keys. Note how the Genie is only partially open during this stepīefore you do anything else, you need to erase the other codes.Test by entering the PIN and pressing the UP/DOWN arrow key once.Genie Garage Door Remote Programming – Step By Step Instructions Step 1: Erase the Other Garage Door Codes.While the purple light is blinking (30 seconds), go to the keypad, enter the new code you programmed into the keypad, and slowly press and release the UP/DOWN arrow key several times until the door activates.Upon releasing the square button, the blue light will turn off and the long purple button will start to blink.Press and hold the square PROGRAM button (shown in the diagram above) located on the bottom of the motor head, until the round LED turns blue and release the button.Enter your PIN ( from three to eight characters).Test by entering your PIN and pressing the UP/DOWN arrow key once.Wait 30 seconds until the LED turns off.On the wireless keypad, enter your PIN and press the UP/DOWN arrow key 3, 4, or 5 times until the door activates.Use an existing remote to unlock the system by pressing it once only.Press the square PROGRAM button and release again.(Note: If the round, blue LED turns off and the long, purple light starts blinking, go to the instructions for Intellicode 2 below.) Press and hold the square PROGRAM button located on the bottom of the motor unit, until both the round and cylindrical LEDs turn blue.If your door opener does not have an antenna, you have an external receiver, and you'll need to remove the external receiver cover to find the LEARN CODE button and the indicator LED. It is usually behind the light bulb cover, close to the antenna wire. Find the LEARN CODE button and the LED indicator light on your Genie motor unit inside the garage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |